Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Replacing Main Cabinet

Status
Not open for further replies.

DBrewsky

Vendor
Jan 23, 2006
1,381
US
I have an IP Office 500 V2 and need to change out the cabinet. The cabinet needing replacing has a broken LAN ethernet port. It broke off. I think someone tripped over the LAN cable and broke it.. Of course, nobody is fessing up..

Anyways, my question is: Is it as simple as moving the SD Card to the new cabinet? The new cabinet will be brand new, never powered up.


Thanks!

--DB

 
Could be......

If the old one had a virtual Essential license, you will lose that by moving to a new control unit. But the new control unit will configure itself to the release that is on the card.

Are you using the WAN port for anything? Can you change the address and IP routes and just use that port instead?
 
We're currently using the WAN port. But the customer would like it fixed..

They're licensed without the need of the virtual license and they're currently at 9.0.5.

--DB

 
I think I would upgrade to new chassis to 10.X, make a call to lock it in, and down grade to 9.1 if you don't want to migrate the licenses at this time. But it will save you an upgrade license if you ever want to go to R10.

Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'
 
The security settings are stored inside the cabinet, not the SD card. Be sure to redo them.
 
I would beg to differ on the security settings. It is in the chassis but it is also stored as a file named security.cfg. The chassis can be overridden with the file.

Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'
 
budbyrd said:
I think I would upgrade to new chassis to 10.X, make a call to lock it in, and down grade to 9.1 if you don't want to migrate the licenses at this time. But it will save you an upgrade license if you ever want to go to R10.

Good luck with that with the amount of hassle getting licenced for 10 involves.

| ACSS SME |
 
BudByrd
I would also beg to differ
althogh the security settings do indeed apear to be stored in security cfg every time we have moed an SD card to a new chasis the security settings need to be redone.


Do things on the cheap & it will cost you dear
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top