Replacing dual port DTI/PRI cards 1

[probietech]

I just need to know if there is anything I need to do other than take the old card out and replace the new PRI card??? Do I need to disable anything first??

 

[GHTROUT]

I'm certain you could just pull out the old and put in the new, but you 'should' disable each loop first.

--
GHTROUT.com - Help for Nortel Meridian/CS1000 System Administrators
--

 

[bigindian65]

dis Dchs in 96, loops in 60 face plate dis dual pri card. make sure dip switches match old card, install new card face plate disabled, and reverse proceedure.



Mato' Was'aka

 

[nhphoneguy]

Also, if you have a dch daughter board, disable the MSDL in 96 first. I have seen this cause an init if the card is just yanked out.

 

[probietech]

Thank you all so much!! I just wanted to make sure I didn't screw anything up too bad!!! The cards are replaced at this location and I'll replace the other cards hopefully later today!!

Again, thank you all so much for your help always!!!
S.