1965flyfisher
Vendor
I'm looking for some assistance. I have a 8.0.16 Essential edition that I installed about 5 years ago. A few weeks ago the power supply in control unit went bad. I had a newer control unit that I had removed which was built with 9.0.
I installed the SD from the 8.0 into the 9.0 control unit and powered up. All the telephones came up and everything was working correct except I cannot access the system with manager. I get a security warning and eventually gives me a network error that it can't connect to the IPO.
My plan at this point is to recreate the SD card to 8.0.66 thinking the old 8.0.16 could be corrupted.
Any thoughts?
I installed the SD from the 8.0 into the 9.0 control unit and powered up. All the telephones came up and everything was working correct except I cannot access the system with manager. I get a security warning and eventually gives me a network error that it can't connect to the IPO.
My plan at this point is to recreate the SD card to 8.0.66 thinking the old 8.0.16 could be corrupted.
Any thoughts?