Have an issue with connecting to Norstar 7.0 RAD. Have complex scenario, so listen up and hope I explain it so you understand....
1. The RAD Target Line is a DID coming in to a PRI on Option 81C PBX.
2. It routes out thru CDP over a TIE Line programmed with a DChannel to a Norstar remote site.
3. The kicker is - it hits a Cisco Router before it gets to the Norstar.
4. It connects (you get modem tone), but you do not get a Data handshake. Get a message with baud rate, it connects and then we see something like -- RAD data not available, etc.
Any one have any experience with this type of issue and especially going thru the Cisco Routers?
Thanks much!
1. The RAD Target Line is a DID coming in to a PRI on Option 81C PBX.
2. It routes out thru CDP over a TIE Line programmed with a DChannel to a Norstar remote site.
3. The kicker is - it hits a Cisco Router before it gets to the Norstar.
4. It connects (you get modem tone), but you do not get a Data handshake. Get a message with baud rate, it connects and then we see something like -- RAD data not available, etc.
Any one have any experience with this type of issue and especially going thru the Cisco Routers?
Thanks much!