I have Nortel Norstar modular ics (4.0)system with 2 routes : route 001 PRI and route 002 Pool a
Pool a uses 10 analog lines to access the outside line.
I have moved my phone system from one floor to another and after the move only PRI works whereas the pool a doesn't get a dial tone.
(for pri i hit 9 to get an outside line for pool a i hit 2 on the phone unit)
If I unplug the PRI and set route001 to pool a it works fine, but if I plug back the pri set the way it was Pool a doesn't work - I cant figure out is it because of the wiring or is it the programing issue
Thanks
Goran
Pool a uses 10 analog lines to access the outside line.
I have moved my phone system from one floor to another and after the move only PRI works whereas the pool a doesn't get a dial tone.
(for pri i hit 9 to get an outside line for pool a i hit 2 on the phone unit)
If I unplug the PRI and set route001 to pool a it works fine, but if I plug back the pri set the way it was Pool a doesn't work - I cant figure out is it because of the wiring or is it the programing issue
Thanks
Goran