I have two 866 numbers that I dial. One of the numbers connects okay but the other 866 number gives me a 'fast busy' sound. Any ideas why? I have a Definity G3siV6.
1866 is setup in ARS. Both numbers work when I use my cell phone. I am by far not a guru in the phone area so any little or big suggestions would help.
The problem then has to be your carrier that you are directing 1866 calls to. I bypass my ISDN-PRI trunks for all toll-free numbers and route then over my copper ground-start CO trunks, as these are toll-free calls anyway, why tie up ISDN trunks ?
if you have the command 'list trace', do that on the station you are calling from. that will show what actual digits are being outpulsed, and what route pattern and trunk group are being used. possibly there is a ars/aar digit conversion table entry for that particular 866 number
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.