Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Priv.rec/pub reciev in Target line

Status
Not open for further replies.

mackk

Technical User
Oct 23, 2006
15
UA
I want to connect some BCM with VoiP.
Read the manual and tried use "Private networking: Using destination codes".
This works, but not as I want.
I want use Priv.Recieved digit in Target Lines,but so does not work.
Its work only if use Pub.reciev digit.

Why? Prompt a correct way please...
 
You need to have the MCDN keycode installed on the BCM before the system will recognize digits in the private field of the target lines. Otherwise, you would put the received digits in the public field. If you have a PRI or other DID service, you would need two target lines per phone.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top