I would appreciate some help on this in Tampa on an Avaya 430 cm5.2
My PRI- T-1 slips on the list measurement status all day long. There is only 1 span for all calls in and out. I am familiar to the change sync commands but my system does not recognize these commands. I have set my DS-1 to error correction Y. After reviewing some notes I do know that my span is set to the tone board on the Gateway. Is there a way to change it to sync to the network? Would this help?
I can get into the server thru telnet but I dont know any server commands that work or to change this. Can anyone walk me thru this or give me the steps associated to correct this? Or am I on the right track?
Thanks in Advance!
My PRI- T-1 slips on the list measurement status all day long. There is only 1 span for all calls in and out. I am familiar to the change sync commands but my system does not recognize these commands. I have set my DS-1 to error correction Y. After reviewing some notes I do know that my span is set to the tone board on the Gateway. Is there a way to change it to sync to the network? Would this help?
I can get into the server thru telnet but I dont know any server commands that work or to change this. Can anyone walk me thru this or give me the steps associated to correct this? Or am I on the right track?
Thanks in Advance!