shinydonut
ISP
I am trying to configure a policy map for the input traffic of our 7200 router running IOS 12.3.8T4. The commands I'm using are as follows:
Router(config)# policy-map limit-traffic
Router(config-pmap)# class slow-down
Router(config-pmap-c)# bandwidth percent 10
Then I try to apply the policy to the interface:
Router(config)# interface fastethernet 1/0
Router(config-if)# service-policy input limit-traffic
I get the following error:
CBWFQ : Can be enabled as an output feature only.
Using the shape command has the same error message stating that it can only be enabled as an output feature only. While Cisco states that a policy map can be applied for input and output traffic, that does not seem to be the case. Can someone explain to me what is going on?
Thanks in advance!
Router(config)# policy-map limit-traffic
Router(config-pmap)# class slow-down
Router(config-pmap-c)# bandwidth percent 10
Then I try to apply the policy to the interface:
Router(config)# interface fastethernet 1/0
Router(config-if)# service-policy input limit-traffic
I get the following error:
CBWFQ : Can be enabled as an output feature only.
Using the shape command has the same error message stating that it can only be enabled as an output feature only. While Cisco states that a policy map can be applied for input and output traffic, that does not seem to be the case. Can someone explain to me what is going on?
Thanks in advance!