Hey all,
Any help would be appreciated!
Normally my partner does the installs but this one i'm stuck on myself... installed the CICS DR1 expanded, got the extensions and lines wired correctly... system booted up fine, set the square template startup ... everythings good, system has 7 lines, so went in and made 3-7 Appear&Ring... now the problem: Whenever I hit a line button, I get the error after 2 seconds, "not in service", under button inquiry all the lines do show up so its not a set programming issue... i've looked through the entire Installer Guide and the only place this wording shows up, it says Lines may not be enabled, solution? enable them! Well I've went through every single programming option and found no such thing!!! I'm going nuts this should be fairly straightforward LOL...
So again, any help at all would be appreciated!
Any help would be appreciated!
Normally my partner does the installs but this one i'm stuck on myself... installed the CICS DR1 expanded, got the extensions and lines wired correctly... system booted up fine, set the square template startup ... everythings good, system has 7 lines, so went in and made 3-7 Appear&Ring... now the problem: Whenever I hit a line button, I get the error after 2 seconds, "not in service", under button inquiry all the lines do show up so its not a set programming issue... i've looked through the entire Installer Guide and the only place this wording shows up, it says Lines may not be enabled, solution? enable them! Well I've went through every single programming option and found no such thing!!! I'm going nuts this should be fairly straightforward LOL...
So again, any help at all would be appreciated!