Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

phontage softphone

Status
Not open for further replies.

goldrake

MIS
Jun 28, 2008
54
IT
Hi, i ask same info about this?

i have voibe (4 channel) whit 1 ip lcd phone, to use this software i need same license ( i hope yes but my vendor tell me that are included whit voibe card).
i need lanu? or simpli connect to lan where there is voibe.
How to active ?
Can i use phontage from outside the lan?
what difference between phontage and ezphone.
 
Batera!

MorenoT did write this info in another "handle":

The VOIB card for the ipLDK-60 description:
There are two cards.
The old card must have 1,3,4 dip switch OFF and DS 2 ON
The new card could be ALL DS in ON or OFF

Please check this!

///doktor
 
Ok, I have all the switches in Off. How can I know if I have new or old cards?

 
Wait...

If you have working IP phone the VOIB is configurated OK,
the problem is set up Phontage

Doktor:
Can you send me Batera´s download file to check it
 
-> MorenoT:
The data_backup of the ipLDK-60 has been send to your email address.

-> Batera:
We try to give you some hints here in this forum.
BUT have you contacted your dealer.
The Phontage softphone is seen working together with iPECS and ipLDK-24/50/100/300/600, so it should also work with ipLDK-60.

///doktor
 
Thanks Doktor.

I am in contact with MorenoT and with my dealer. I will let you know our success.

Edgar
 
Dear Señores.

? Va bien?

How did it go with your tests and evaluations of this issue?
If I faced problems like this I would reset the system to factory defaults, and the manually re-program the PBX.
Also I would check for the latest firmware for the VOIB board. Finally this issue could end up in hardware faults.

///doktor
 
I will check when I can do this, maybe the weekend. I´ll let you know the results, because until today still not working.

regards,

edgar robles
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top