The printer does power up succesfully and go through complete warm up and self check. When I tried to print documents from the printer it stated various errors. The errors were that the paper trays are empty, however, when paper is in the unit they state that the drawers are not installed correctly. Any ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 7700 No Paper message
- Thread starter jim1452
- Start date
- Thread starter
- #3
- Thread starter
- #5
Does it have an LTA on it?
If so reseat the connection for the lta.
If not pull the paper tray out and inspect the board behind the tray. make sure it isnt loose and doesnt have any loose connections. Make sure all the tray guids are set right and that none of the pins on the back side of the tray are broken. Make sure that no paper scraps are behind the tray either.
If so reseat the connection for the lta.
If not pull the paper tray out and inspect the board behind the tray. make sure it isnt loose and doesnt have any loose connections. Make sure all the tray guids are set right and that none of the pins on the back side of the tray are broken. Make sure that no paper scraps are behind the tray either.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question