Paging with Valcom V-2001a

[ValiantSoft1]

I have an IPO 9 with 2 combo cards and a V-2001a with 2 speakers. Paging was working great by using an analog port set as paging speaker with short code:
*78
Dial Paging
207
0
After a reboot it stopped working. I have tried suggestions from thread:

http://www.tek-tips.com/viewthread.cfm?qid=1737950.

Still not working

Also found this thread:

http://www.tek-tips.com/viewthread.cfm?qid=1724470

from bobertb with no attachement

Any suggestions?

 

[Westi]

when you hook a butt set into the analog port and turn it to talk, do you hear the page?
if yes then the issue is with the Valcom if not then with the IPO

sorry I did not read the other threads that you linked in here if that was there then forget about it

Joe W.

FHandw, ACSS (SME), expired ACIS (SME)


"This is the end of the world, make sure to buy your T-shirt before it is too late"
Original expression of my daughter

 

[ValiantSoft1]

I do hear the page using a buttset

 

[Westi]

Then the problem is with the Valcom
You could try a matching transformer but if it worked in the past then that should not be the problem.
When you put you toner on the Valcom, do you hear it over the speakers?

Joe W.

FHandw, ACSS (SME), expired ACIS (SME)


"This is the end of the world, make sure to buy your T-shirt before it is too late"
Original expression of my daughter

 

[ValiantSoft1]

Yes I do

 

[Westi]

then it is a mystery why it won't work.
Try to monitor with the butt set and see if you can hear the pages, again if you do it is a Valcom issue.

Just remembered that the IPO will give you a busy signal when you page and it doesn't recognize the paging port as valid, meaning 600 Ohm impedance.

Joe W.

FHandw, ACSS (SME), expired ACIS (SME)


"This is the end of the world, make sure to buy your T-shirt before it is too late"
Original expression of my daughter