OTM on a CS1000

[GarenCAnderson]

Good afternoon everyone,
I have 6 CS1000 PBX's that I am currently managing.
I need to get call accounting / CDR functionality on to them.

They used to be connected to OTM back when they were Option 11's.

Using my OTM software, is it possible to get these PBX's back on to the OTM system so I can pull reports again?

Is there any documentation I can follow?
I'm not the smartest when it comes to my PBX's and could use any help that anyone is willing to offer.

Thanks in advance for your time.

v/r
-Garen

 

[Firebird Scrambler]

What versions are all your CS1K?s? I seem to recall that from Version 7.x OTM / TM was no longer used and therefore you can't pull off CDR reports by the DBA function contained within OTM / TM. You can still use the serial port.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[janaya]

yes, the version of TM/OTM is specific to CS1000. I have a site that uses 4.2 and it works fine.

John Anaya
Signet6 Network Sciences
ACSS/ACIS - CS1000 Rls 7.5/Call Pilot 5
ACSS/ACIS - SME - IP Office 8.0
APSS/APDS - Avaya UC Services

Public Profile

http://www.linkedin.com/pub/john-anaya/25/1b9/a9b/Edit