I having a little problem with saving OSPF config. According to the lab objectives, I can't use "Ip ospf network" command. So I went ahead and statically defined OSPF neighbors (using point-to-multipoint sub int). I saved the running config and reloaded the router to make sure that nothing breaks after a reboot. Sure enough, I couldn't see OSPF neighbors. I checked the running config to make sure that everything was ok and found that neighbor statements were gone. I added them again, saved the config and restarted....same problem. I even switched a router but no luck. I'm assuming that it's not the hardware issue at this point. Any ideas?
Thanks in advance for all your help.
Thanks in advance for all your help.