phone_troll
Programmer
My notes for ordering CCIS in the past is that I provide clocking to telco instead of them to me...is that correct? Or should I let them provide the clocking?
Thank you
Thank you
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Ordering CCIS for SV9100...Clocking Question 2
- Thread starter phone_troll
- Start date
- Status
-
1
- #2
belevedere
Instructor
Always clock from telco whenever possible. They have a higher stratum (accuracy).
-
1
- #3
If you are doing this point to point T1 CCIS you will have to have one system as clock the other as slave. If one system has a T1 or PRI for dial tone you SHOULD set that system for slave and clock off that and make that master for the PTP CCIS T1. Point to point circuits never provide clock.
- Thread starter
- #4
phone_troll
Programmer
CoralTech -- its for a Point to point CCIS. Neither system has a T1 or PRI -- they both run SIP trunks. What to do in that scenario?
- Status
