jeanvaljean
Vendor
OTM was recently reinstalled due to a PC failure. New PC is Windows XP, OTM is installed, and basically working but it will not successfully do the "ld 20, prt, tnb, rtn, rtn, rtn, etc. to execute a "Retrieve All" so that Station Administration could be used.
It does actually connect to the switch (Rls 3 Opt 11C Cabinet) via IP - not via modem (so modem scripts do not apply, right???)
Also you can open the "ystem window" in the OTM and have the 'above and below' dialogue windows so you can act on the switch from the OTM PC.
But so far it will not do the necessary 'Retrieve All'; again, it connects, but doesn't carry out the PRT, TNB, etc.
What am I missing here??
thanks
24601
It does actually connect to the switch (Rls 3 Opt 11C Cabinet) via IP - not via modem (so modem scripts do not apply, right???)
Also you can open the "ystem window" in the OTM and have the 'above and below' dialogue windows so you can act on the switch from the OTM PC.
But so far it will not do the necessary 'Retrieve All'; again, it connects, but doesn't carry out the PRT, TNB, etc.
What am I missing here??
thanks
24601