Option 11C and NI2

[schasak]

I have an Option 11C connected to an Option 81C with a PRI and can dial out fine from a phone off the 11C over the tie line to the PSTN. I have some type of Solantro router that my IT department is trying to hook and use for VoIP. I have a PRI from the 11C to the router NI2 with a DID & Tie service route. I am able to receive incoming calls to the router and also station to station calls. The problem is I cannot make outgoing calls across the PRI to the 81C. I have turned on D-Channel messaging and I am receiving the proper digits, but I receive reorder everytime. The NI2 tie route is setup with an NCOS of 6, the same as a phone set that I can use to dial out on with no problems. The problem seems to be with the tandem connection. Any ideas?

 

[Avaya911PLM]

Post the DCH messaging from a failed outbound call.

--
Fletch
Visit the Nortel Technical Support Portal at:

http://www.nortelnetworks.com/support

 

[johnpoole]

on your 81, does it reject the call, and show routing to reorder or is the 11 sending the call to reorder, as above pls post the msgi/msgo message from each switch.. also are you using dsc tsl lsc?..what routing are you using between the two switches, in the 11 i would turn on vacant number routing to the 81, the build cdp tables from the 81 to the 11

john poole
bellsouth business
columbia,sc

 

[schasak]

Didn't seem to have any luck with the NI2 integration, even Nortel Support could not seem to get it to work. We went with a DMS100 integration and it seems to be working fine.

Thanks for your assistance anyway.

 

[agpham]

I had the same problem getting an Opt 11 to work with a VoIP product with NI2 signalling. Ultimately, I built it as a TIE group running 5ESS.

 

[RickJPlett]

Hi,

Had the same problem here. Look at the flip channel bit on the router configuration. Change the value and see what happens.