Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Opt61c - Miran - Fast Busy
- Thread starter KZ9Y
- Start date
- Thread starter
- #5
Thanks for your assistance so far.
Update:
DISC'd and ENLC'd the MIRAN card 4 0 1 (L,S,C,). No alarm before or after software reboot.
Still getting fast busy.
Pushed reset button. Card appeared to boot normally. No hex codes, no red alarm.
Still getting fast busy.
Did DNB on the MIRAN access code 7107 and it points to:
TYPE RDB
ROUT 7
This MIRAN card has been working OK for over 5 yrs. Changed a couple of recordings a couple yrs. ago. We were just trying to change a recording again and poof! No access!
>****
Update:
DISC'd and ENLC'd the MIRAN card 4 0 1 (L,S,C,). No alarm before or after software reboot.
Still getting fast busy.
Pushed reset button. Card appeared to boot normally. No hex codes, no red alarm.
Still getting fast busy.
Did DNB on the MIRAN access code 7107 and it points to:
TYPE RDB
ROUT 7
This MIRAN card has been working OK for over 5 yrs. Changed a couple of recordings a couple yrs. ago. We were just trying to change a recording again and poof! No access!
>****
- Thread starter
- #7
Co-worker and I succesfully logged in last wk. Using same phones now. No config. changes on the phones since we logged in.
Actually, what failed first was an attempt to change/remove a recording. MIRAN told co-worker he didn't have access. Since then logging in has failed. So, we're trying to fix the login problem first. It's getting uglier by the minute!
>****
Actually, what failed first was an attempt to change/remove a recording. MIRAN told co-worker he didn't have access. Since then logging in has failed. So, we're trying to fix the login problem first. It's getting uglier by the minute!
>****
Firebird Scrambler
Systems Engineer
Are you using an analogue phone to log in with?. Also can you log in via the serial port connection or do you have ethernet access?.
All the best
Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK
If it's working, then leave it alone!.
All the best
Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK
If it's working, then leave it alone!.
- Thread starter
- #9
- Thread starter
- #10
Solution:
Chanel 7 was disabled. That was the main culprit.(I didn't catch that as chanels 0 - 3 were IDLE). Chanel 7 was ENLU'ed and went idle but I still was not able to modify recordings. MIRAN card was DISC'ed then removed from backplane and put back in. Card was ENLC'ed.
All is well with MIRAN now.
Thanks all,
>****
Chanel 7 was disabled. That was the main culprit.(I didn't catch that as chanels 0 - 3 were IDLE). Chanel 7 was ENLU'ed and went idle but I still was not able to modify recordings. MIRAN card was DISC'ed then removed from backplane and put back in. Card was ENLC'ed.
All is well with MIRAN now.
Thanks all,
>****
- Status