Old autocad command

[Guy405]

On some past version, there was a command where you could trim multiple lines at the same time. By clicking on a crossing line then clicking on the side you want all the lines trimmed to. Does that command still exist for AutoCAD 2005 LT?

Also, is there not a way to add layers into groups and toggle the freeze/layer off at the same time?

 

[TCARPENTER]

Hi Guy,

I seem to remember something similiar to this also but it was a lisp routine not an internal command. You might check either

http://www.caddepot.com

or

http://www.cadshack.com

and see if you can find a listing for it in either one of these sites.

HTH
Todd

 

[borgunit]

Select trim, then the trim line, then type in F for fence, draw a line to "hit" all of the trim objects and then enter.

 

[ccastelein]

theres also the cookie cutter trim...
now only available with express tools via the command line
"extrim"

cdc

 

[MGher]

Command you are searching is "Fence". Just type F when a selection is needed and click 2 points.... u will see a "crossing selection" line instead of the usual rectangle.

Best Regards,
Marco