Also was building ntbk51aa msdl card in slot 26 of network group zero shelf one getting sch5575 after trying dnum and port zero or one for dchannel device invalid msdl physical address
Thanks KCFLHRC for the response I thought that was the case on the msdl card only neededed power from the backplane. The issue I was having I had installed the nt5d12 for loops 26 and 27 this is a 3 group cs1000m machine release 7.50. I had set the ntbk51 for dnum 13 I was building the dchannel card and I got the sch message 5575 so I tried ever device number still the same this was in group zero . So I tried in group one it would take the information. I when back to check the devices build could not find a conflict with number 13. Their was two devices build for msdl card onboard type in group one 9,10 so I could build this dchannel on 11,12,13,14,or 15 in group one. I know that the documention said only 16 devices for the hole system. I guess my only other question is can you build msdl card in group one for a nt5d12 in group zero I assume so. The reason for this set up is no space to add the ddp card with out adding a fourth network group. Thanks for your comments
Thanks for the reply buddy, it has been a wait on nt6d80 for the dnum setting if I want to use 11 for the device number is that 1 on the tens switch and 1 and ones switch.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.