Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

No tones on the phones

Status
Not open for further replies.

Ghoulam

Technical User
Feb 8, 2012
74
DZ
Hi guys
I have one MD110 TSW SP3 version, there is no tone on all the phones, and when you call any extension; it rings one time and then stop, but the communication is established,
Is it the TMU board, that can do these two problems, I found an alarm about TMU but it's class zero:

324 FAULTY TMU BOARD
DATE TIME ALP NOIF EQU BRDID INF1
15MAY13 00:28:58 73 5 002-0-10-00 102 2

 
Hi,
you can try software restart (RFBOI) or hardware restart of TMU board or change the board.
 
You say all the phones are affected, but the alarm is from LIM 2 in May!
Is the problem still there?
Is it in all LIMs?
Is it on analogue, digital, or both?
Any other alarms?
What lost signals (HIMDP)?
 
Yeg all the phones lim1 & 2, digital & analogs
I don't have HIMDP sorry

the date is wrong

here are all alarms:

<ALLIP;
ALARM LIST
IDENTITY: EPC-1ALGERIA
VERSION: CXP1010123/4/TSWSP03/R4A

DATE: 22MAY13 TIME: 15:31:08
CODE CLASS NOAF EXPLANATION
15 2 1 DEVICE BOARD FAULTY OR MISSING
30 1 1 INCREMENTATION ALARM FOR ALARM CLASS 0
31 2 1 INCREMENTATION ALARM FOR ALARM CLASS 1
38 1 2 DISTURB. COUNTER INCREASED DUE TO FAULTY PROGRAM EXECUTION
40 1 1 EXCHANGE DATA RELOADED
45 1 1 LIM RELOADED AND RESTARTED
78 4 1 NO CONTACT WITH STANDBY SIDE
106 3 3 FAULTY I/O BOARD OR CONNECTED I/O DEVICE
114 1 3 DEVICE BOARD HAS BEEN ACTIVATED
115 4 1 SIGNAL PACKET LENGTH REDUCED
260 1 22 FAULT ON LINE TO INTERWORKING PABX OR PUBLIC EXCHANGE
269 4 1 DIGITAL TRUNK, LOSS OF FRAME SYNCHRONIZATION
274 2 1 DIGITAL TRUNK, CLOCK MALFUNCTION (SLIP)
278 3 2 CIL DATA LOST FOR ONE OR MORE OUTPUT UNITS
320 1 2 HIGH CALL RATE
344 2 1 CIL, FAULTY CONNECTION TO NIU PORT
 
lscnp;

need to print and gjtsp:lim=all;
to final fault

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top