New to Cisco, Need help setting up 2811 with HWIC-Cable-D-2

[ReeceSavage]

i will just start with the fact that I am a total Cisco newbie.

I have a 2811 with a HWIC-Cable-D-2, a HWIC-AP-G-A, and a VIC2-2FXS.

We had this router left over after we changed data vendors and it was always managed so I have never had to touch it. Anyway I was given permission to take it home since we won't use it.

This is my goal.

I want to use the HWIC-Cable-D-2 for my WAN from my cable company. I want my lan on FastEthernet 0/0. I want the HWIC-AP-G-A to be a wireless access point for my LAN with WPA Personal. I want to setup SIP and QOS for my VOIP phone service and use the VIX2-2FXS to connect to my phone jacks.

I'm pretty sure I got NAT and DHCP going, but that is about all. I spoofed the MAC address for my current cable modem and tried to bring it up but it doesn't sync up. I know this is asking a lot but any help would be appreciated.

Thanks,

Reece
reece.savage@gmail.com

 

[burtsbees]

Post a sh run.

Burt

 

[ReeceSavage]

As soon as I get home tonight I will post one. Thanks for responding.

-Reece

 

[ReeceSavage]

Here is the information. Again thanks.

Building configuration...
%The cable modem firmware does not support RIP relay

Current configuration : 3646 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname mississippi
!
boot-start-marker
boot-end-marker
!
logging message-counter syslog
logging buffered 51200 warnings
enable secret 5 $1$mHRD$nasYkOi6Gomooy1twLklj/
enable password ********
!
no aaa new-model
!
dot11 syslog
ip source-route
no ip routing
!
!
no ip cef
ip dhcp excluded-address 10.1.1.1 10.1.1.50
!
ip dhcp pool ihdhcp
!
ip dhcp pool DHCP_pool
   network 10.1.1.0 255.255.255.0
   default-router 10.1.1.1
   dns-server 67.138.54.100 207.225.209.66
!
!
ip domain name rsavage.com
no ipv6 cef
!
multilink bundle-name authenticated
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
voice-card 0
!
!
crypto pki trustpoint TP-self-signed-2293666269
 enrollment selfsigned
 subject-name cn=IOS-Self-Signed-Certificate-2293666269
 revocation-check none
 rsakeypair TP-self-signed-2293666269
!
!
crypto pki certificate chain TP-self-signed-2293666269
 certificate self-signed 01
  3082024F 308201B8 A0030201 02020101 300D0609 2A864886 F70D0101 04050030
  31312F30 2D060355 04031326 494F532D 53656C66 2D536967 6E65642D 43657274
  69666963 6174652D 32323933 36363632 3639301E 170D3039 30343235 31353331
  30345A17 0D323030 31303130 30303030 305A3031 312F302D 06035504 03132649
  4F532D53 656C662D 5369676E 65642D43 65727469 66696361 74652D32 32393336
  36363236 3930819F 300D0609 2A864886 F70D0101 01050003 818D0030 81890281
  8100F25E 1CB5B2F4 828403C4 329DD9AB 2DCDA84C 5571AEA3 A5D48AF1 D01E65A0
  56531D20 3A90967D 73D1E75E 6DC3891E 65CC02C4 38148BE9 891C86C8 F1DFCA81
  16A67278 F830940A D14F7ABE 8122B582 45F14960 97920A1A FBB5E2C3 D1D1E129
  86FDD34D AC1F70E4 0FCA3C05 A1AAF7D5 B8FA5DBB F0283BE5 44ACEA0C CCA4481C
  50DD0203 010001A3 77307530 0F060355 1D130101 FF040530 030101FF 30220603
  551D1104 1B301982 176D6973 73697373 69707069 2E727361 76616765 2E636F6D
  301F0603 551D2304 18301680 14D0E373 832476C2 B13A927B 2AA29B04 20A73C05
  F3301D06 03551D0E 04160414 D0E37383 2476C2B1 3A927B2A A29B0420 A73C05F3
  300D0609 2A864886 F70D0101 04050003 818100E2 4839464D A3036D56 DCEE8B1A
  A780012A FA27AA28 B57467FB A9548802 8F04996A 9D83B15A C302BA01 1D1E944C
  4C72CA43 91CC7854 F9878868 ADABCA09 6C626735 60F25BAC FAADE9BB E4075324
  6886043C 0473E121 AF67DACD B3F9B01B EB260C75 32F4C194 37398A44 C6F723A5
  DAAD979E 7BAAA1C8 6858672C BB3BC9F5 57C2EE
        quit
!
!
username reece privilege 15 password 0 [******** | ********]
username linkpf privilege 15 password 0 ********
archive
 log config
  hidekeys
!
!
!
!
!
ip ssh version 1
!
!
!
!
interface Cable-Modem0/0/0
 mac-address 001a.deac.1348
 ip address dhcp
 ip nat outside
 no ip virtual-reassembly
 no ip route-cache
!
interface FastEthernet0/0
 ip address 10.1.1.1 255.255.255.0
 ip nat inside
 ip virtual-reassembly
 no ip route-cache
 duplex half
 speed auto
 no mop enabled
!
interface FastEthernet0/1
 no ip address
 no ip route-cache
 shutdown
 duplex auto
 speed auto
!
interface Dot11Radio0/1/0
 no ip address
 no ip route-cache
 shutdown
 speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
 station-role root
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 Cable-Modem0/0/0
ip http server
ip http authentication local
ip http secure-server
!
!
ip nat inside source list 1 interface Cable-Modem0/0/0 overload
!
access-list 1 permit 10.1.1.0 0.0.0.255
!
!
!
!
!
!
!
control-plane
!
!
!
ccm-manager fax protocol cisco
!
mgcp fax t38 ecm
!
!
!
!
!
!
line con 0
line aux 0
line vty 0 4
 privilege level 15
 password ********
 login local
 transport input all
!
scheduler allocate 20000 1000
end

 

[burtsbees]

First thing---enable ip routing...

mississippi#conf t
mississippi(config)#ip routing

I have not looked past this yet, as it is past my bedtime

More tomorrow, unless this fixes it---you definitely need it to make it past switching!

Burt

 

[ReeceSavage]

Thanks for the responce. I can't test the router from work, but i can update it. I added that, and will let you know if it works tonight. If you see anything else in the config though today let me know and I will get it added.

Again thanks.

-Reece

 

[ReeceSavage]

Didn't fix it. I do get a address from DHCP from my pool, but no internet connectivity. After a minute or so after the router cycles up i get something like

interface cable-modem0/0/0 link status set to down.

It doesn't seem to be syncing up to the cable company. I read on Cisco's site that the MAC address for that card was not changeable, but it still let me set it in the config. Maybe it really isn't changing? I have no idea I am just guessing. The issue with changing it is that my current modem will no longer work and that makes it hard to get this network going.

Perhaps there is some config settings I need for this cable modem card?

-Reece

 

[ReeceSavage]

Hey guys anyone have an idea on how I should proceed here? I move on the 15th and would like to have my router up and going by then.

Thanks,
-Reece