Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

New drops added

Status
Not open for further replies.

tirk

IS-IT--Management
Aug 13, 2009
66
US
When new drops are added and punched down, what must I do to make them active?

Do I have to assign ports or should I have a dial tone initially?
 
IF you have TTI active, you'll have dial tone. If TTI is turned off, there'll be no dial tone.

SEARCH for TTI on the forum.
 
You can TTI in the phone if it is turned on in your system. Or assign the port to the change station form in the PBX in the port field.

Rock on, be strong... SG
APDS UC, APDS CC, ACE IP Telephony
 
what if tti is on and Ive never had dial tone from the time the vendors punched it down?
 
It's gotta be punched down wrong. Are you using 110 blocks, 66 blocks, or patch panels?
 
If you have no dial tone with TTI on, either the cross connect is going to the wrong type of circuit pack for the phone set, or it could be a wiring issue.

Rock on, be strong... SG
APDS UC, APDS CC, ACE IP Telephony
 
Terminal Translation Initialization (TTI) Enabled? y
TTI State: voice TTI Security Code: 55


Default COR for Dissociated Sets: 1
CPN, ANI for Dissociated Sets: xxx-xxx-xxxx




I have no idea what blocks or panels are used. Its our HQ office quite a few states over...but we have some pics.

And after investigating online and comparing, its the 66 blocks.
 
So you've got an amphenol cable coming off of a circuit pack or a media module and going to a 66-block. And you've got a phone that your cabler states is wired correctly.

Hmmmmm..... maybe you have a split-66 and you need a bridge clip?
 
ill take your word for it.
 
That's just a guess, get someone at HQ to test each side of the block, or get the original cabler back out to verify their work.

There are all kinds of little things that can get you that we don't know are going on.

Sometimes people change from a 8-port to a 16-port/24/port pack/mm and need to re-wire because some ports are not providing tone.

You need a helping hand right at the block.
 
I have one but hes just a contractor and less informed than me which is almost impossible.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top