I hope someone can help. I was handed a partner II R3
with partner mail R3, recently relocated. Several problems
from VM that I have managed to correct. All that is left
is this: the message lights are not turning on when a new
message is present. I can use Ftr 09 and verify that they work. All 4 ports of the 206 module will dial out correctly. All 4 ports on the VM sys. indicate good.
I understand that the lights are controlled by the VM, but
don't see any way of making sure the strings are present.
Does anyone have a clue?
Any suggestions would be great.
Thanks,
Cat5guru
with partner mail R3, recently relocated. Several problems
from VM that I have managed to correct. All that is left
is this: the message lights are not turning on when a new
message is present. I can use Ftr 09 and verify that they work. All 4 ports of the 206 module will dial out correctly. All 4 ports on the VM sys. indicate good.
I understand that the lights are controlled by the VM, but
don't see any way of making sure the strings are present.
Does anyone have a clue?
Any suggestions would be great.
Thanks,
Cat5guru