Network BCM50 and BCM400 4

[jimmers]

Im trying to network a BCM50 with BCM400. I'm using VoIP trunks with H.323 between the two. No matter what extension I dial, it goes to the prime set on the destination BCM. Here are my specs.

Private and received numbers set to 3 on both BCM's
Private network type is CDP
Private DN length is set to 3 on both BCM's
Virtual private network ID is set to 1 on both BCM's
VoIP lines are added to the same pool
My route is using the VoIP pool
I created a route in my VoIP trunks using the other BCM's IP
GW type is BCM
GW protocol is CSE
VoIP protocol is H.323

Any help would be much appreciated!

 

[endlesswinter]

The way I discribed will allow you to dial extensions directly. Your routing table said 71 so I assume your dns are in the 71X range. On the other side set your recieved dits to rec 71x and it should work.

 

[hawks]

I also noticed that you had calling plan as CDP but you also had a Location Code set up.

 

[jimmers]

Well I finally got it to work just dialing the 3 digit extension. My only question is why it only works when I set absorb to all. If its set to all, wouldn't it absorb the first digit and just send out the last 2?

 

[hawks]

No the Absorb only affects the Desti Code not the other numbers.
example:
Desti 72 Abosrb 0
If you dial 72300 then all digits go out.

Desti 72 Absorb All
You dial 72300 only the 300 will go