Need help on Mxe

[hassanyousif]

Hi every body
Im new to mitel world . I have to deploy Mitel in two sites
I installed CXi controller in one site and it is working locally and through PSTN properly.
The second site has Cisco call manager and Cisco 2811 as a voice gateway which connected to 6 PSTN lines , We are going to install Mxe controller in this site which has Dual T1/E1 framer to connect to the 2811 router ( also has E1 card installed on it ) , the connection will be with QSig
-- I started to configure the PRI QSig digital trunk on the Mxe but i got confused and mixed it .
I hope any one can help me on the following
1- I want to erase the current config on the Mxe
controller (Trunking config) so I can start the config
from scratch
2- if someone can give the configuration steps for the E1
PRI QSig digital trunk
3- In the first site the users want all the telephones to
ring when call come from out side (now I determined one
Answer point )

I hope I can get help from you
Thanks in advance

 

[tlpeter]

If you want it to have an empty database then go to maintenance and give it a dbms flagg off and a system reset

This will erase everything include licenses wich have to be added to the machine again !!!

For making the E1 just go down and fill in everything and use the help


ACA - Implement IP Office
ACS - Implement IP Office
ACA - Implement IP Telephony
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!