MPA on CX-II, or MXe-III

[AH64Armament]

Has anyone here managed to install the MPA probe blade on a 3300 ICP that is running on a CX-II or MXe-III?

I have a site that has an older Marwatch probe, and of course Martello support has told me to contact Mitel Support. Mitel Support basically said they don't know anything about any such device.

The site's probe shows last check-in was Sunday and remote access isn't available. I have another probe (same older model) and am trying to get it to register to the account.

 

[Hemonious]

I've been told the CX-II and MXe-III do not support an embedded MPA probe. Only virtual servers, EX or the SMBG controllers support an embedded MPA probe. Where I work, we've deployed physical MPA probes for this purpose. Martello has since stopped selling the probes that we deployed a couple of summers ago, but I believe they are supporting raspberry pi now.

 

[AH64Armament]

I've been told the CX-II and MXe-III do not support an embedded MPA probe. Only virtual servers, EX or the SMBG controllers support an embedded MPA probe. Where I work, we've deployed physical MPA probes for this purpose. Martello has since stopped selling the probes that we deployed a couple of summers ago, but I believe they are supporting raspberry pi now.

That's what I thought too. Figured I'd check while trying to fix this old shiva plug probe.

I did get it to work. It just took a while for it to appear as checked in and ready. I repeated the process twice before I noticed it happen.