Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

NEC SV8100 PRI not calling out

Status
Not open for further replies.

nftech

Vendor
May 26, 2005
7
CA
HI have an NEC SV8100 with a PRI. All was working good till telco introduced ten digit dialing here in NL a couple of weeks ago. On out going calls caller should be able to dials 9 709 xxx xxxx but they are getting busy signal after 9 them 7 digits ( 9 709 xxx x ) The weird thing is I can program lines on a set and they can dial out using line key with the 10 digits ok. I can also press #9 and select any trunk and place the 10 digit call no problem. It is just when I dial 9 and then try to dial the e10 digits I get cut off after 7
 
Hi Sinjisn thx for your reply, it was froute table, table 3 programmed for 7 digit max instead of 10.

Thanks again
Derm
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top