Moving PRI from T1 to Adtran 924e

[solidtechnw]

We are porting our lines from the current configuration which is: Mitel SX 200 ICP PRI to Integra CSU/DU (T1) to a new Century Link 250/250 Fiber line via a new Adtran 924e that has been configured by Century Link prior to deployment on site.

We are pure UC Vendors and have some questions about the porting for the Mitel SX 200 ICP specifically, We are aware that the SX 200 ICP needs to see the line as PRI and we have facilitated that, the question we have is are there any other changes that need to be made on the Mitel SX 200 ICP.

thanks

 

[jrgood0852]

I'm not up on the 200, but on the 3300 you would need a T1 cross-over cable if connecting to the Adtran. Anyone else?

Always look out for the next tech. because one day it will be you!

 

[kwbMitel]

Protocols must match (NI-1 vs NI-2)

Digits received must match - Quantity of digits 10, 7, 4, other

**********************************************
What's most important is that you realise ... There is no spoon.

 

[kwbMitel]

Further to my post above

Form 42 will tell you the existing Protocol values - (DMS-100 = NI-1)
- Additionally the termination mode can be modified from NT to LT to avoid a X-over cable if required.

Form 15 will show the current expected digits and how they are modified

Field N - Number of digits
Field M - Digits absorbed
Field X - Digits inserted

The N and M fields may need to be modified to match the new carrier but don't touch X

**********************************************
What's most important is that you realise ... There is no spoon.