Hi All,
I've got a Fujitsu 9600 system I'm having a problem with, and only a limited knowledge of the commands to configure it. I'm using MML, but I'd love if anyone could point me in the direction of a copy of the EMML software.
My problem is that I took our voicemail computer offline for a little over an hour, reconnected it only to find that the 9600 faulting on DCU1 (if I recall correctly). I had assumed it would recover if I gave it enough time, but it's been about 16 hours and it's still not communicating fully with the VM system. Is there a way to restart the phone system using MML, and is this advisible? Or maybe I need the command to cancel the fault? I think I know the command to cancel a fault on a particular port, but I'm not sure if it will work in this instance. Any help you can offer is greatly appreciated!
Brian
I've got a Fujitsu 9600 system I'm having a problem with, and only a limited knowledge of the commands to configure it. I'm using MML, but I'd love if anyone could point me in the direction of a copy of the EMML software.
My problem is that I took our voicemail computer offline for a little over an hour, reconnected it only to find that the 9600 faulting on DCU1 (if I recall correctly). I had assumed it would recover if I gave it enough time, but it's been about 16 hours and it's still not communicating fully with the VM system. Is there a way to restart the phone system using MML, and is this advisible? Or maybe I need the command to cancel the fault? I think I know the command to cancel a fault on a particular port, but I'm not sure if it will work in this instance. Any help you can offer is greatly appreciated!
Brian