Im quite new to the Mitel Standard Linux and its teleworker blade application. Just started my firt installation and already having a problem. The teleworker is being deployed in server only mode and is only being used on the local lan, so no publicly routable address or anything. I have installed the MSL and blade and just installed one phone to test. I can initiate a call to and from the teleworker but there is no audio or rtp stream. I have defined my local subnets in local networks tab. Under the "router" information, I have put in the same gateway as used for the teleworker nic itself. There shouldnt be any nat settings/port forwarding as all of the communication is behind the firewall. Can anybody shed anymore light on this ?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mitel Standard Linux 1
- Thread starter casioman
- Start date
Canuckvoip
Technical User
Thanks KWB,
I will remember that!
Matt, thanks for that.
Will come in handy!
Dave
You can't believe anything you read... unless of course it's this.
I will remember that!
Matt, thanks for that.
Will come in handy!
Dave
You can't believe anything you read... unless of course it's this.
- Status