Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mitel Major Trunk Alarms

Status
Not open for further replies.

Avayabenjnew

Technical User
Jun 12, 2024
9
AE
I need help please! With Mitel Major Trunk Alarms
I have attached a photo of the alarms.

I able to clear the PRI alarms by using DTS command
But this other trunk alarms I cannot 🥺
How can I clear this alarms?

IMG_20240722_132914_bg5twj.jpg
 
You have trunks out of service. You need to either restore the trunks or deprogram them to clear the alarm.
 
Thanks Lundhafor the reply.
How will I know which trunk do I need to check?
Because when I check the alarm this message are appearing. Sorry for the question I am really new with Mitel 🥺
 
What type of trunks does your system have connected - PRI, SIP. Analog LS/GS. E&M?
 
SXWizard
I have cleared the PRI alarms using DTS command.

But this sip I cannot
 
can you issue the SIP LINK STATE ALL command in maintenance to see wha SIP link is down?
 
SXWizard
I have done the SIP LINK STATE ALL
The response are

There are 2 SIP link(s) programmed.
Link sipfcs state is IN SERVICE (link down count 67)
Link sipsp state is IN SERVICE (link down count 13)

What should I do now?
Sorry for asking but I really need the support.
 
It appears that you have PRI and SIP trunks. Are there any other type of trunks connected to the controller - E&M or LS/GS?
 
SXWizard

How can I list all those trunks?

I am sure we have PRI and SIP
 
Login and celect trunks. Then select Analog trunks>Trunk Assignment to see if you have analog trunks. Do the same for E&M Trunks.
 
SXWizard
Sorry for the late response


Analog trunks
Cabinet shelf. Slot. Circuit. Card type
2. 1. 1. 5-10 Hybrid 4 ONS 6LS


E and M Trunks
Cabinet. Shelf. Slot. Circuit. Card type
2. 1. 3. 1. 1 port E&M Trunk

IMG_20240805_115339_xjfrmr.jpg
IMG_20240805_115404_u1qsnt.jpg
 
Go to Maintenance commands and run the State command on each of those PLIDs. Look for something Out of Service etc.
 
I think you need to use a direct trunk select and select each trunk individually until you find out which ones don't have connect with the phone company. If it doesn't connect with the phone company it needs to be disconnected from the phone system in many ways due to licensing.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top