Mitel 3300 Security alarm

[kwbMitel]

It's been too long since I've seen one of these.

I know what caused it but I can't figure out how to get rid of it.

Last time my system was running 5.X and I seem to remember it took a reset of the system to clear it.

Now the system is running MCD 4.2 and I'm hoping there is a simpler solution.

Anyone?

**********************************************
What's most important is that you realise ... There is no spoon.

 

[Supernova99]

just need to go to maint commands any type show fault alarms
and it will clear

Share what you know - Learn what you don't

 

[thelatman]

Hi,

To rid yourself of the security alarm:

Set thresh security n n n

Lat

 

[LoopyLou]

The only alarm I remember relating to security was using default passcodes on a system. You had to change them to something else to get rid of the alarm.

I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.

 

[kwbMitel]

This was caused by OPSman logging in with the wrong passcode mutiple times.

For anyone using the 6.2 version of OPS. (maybe older as well)

The passcode as entered into EMan will be changed with the sync to OPS if there are any capital characters. Eman will work, OPS will not. Passcodes must be lowercase only.

**********************************************
What's most important is that you realise ... There is no spoon.