Hi, folks. I administer a cluster of 3300's. In our environment, we also have SRC's and a MAS(NuPoint, UCS and MCA). We're running low on IP addresses in the VOIP subnet at one of our sites. I'm planning to expand the address pool on the DHCP server that services that site. I need to know all of the places where an IP address range might be configured. Where in the 3300 and the SRC do I configure these ranges? Also, is this just limited to the 3300 and SRC in that site or will I have to make changes to the applications hosted on the MAS? Any information\advice is appreciated. Thank you.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mitel 3300 and DHCP scope saturation
- Thread starter TechFats
- Start date
The 3300 has it under DHCP and the MAS products have a local networks tab where you need to define all the subnets where phones could be located. You can use a MAS ( which may be supporting the SRC/Nupoint/UCA ) as a DHCP server and it also has a tab for it. Was wondering in a new VLAN and subnet might be easier but I don't know you situation.
You can't duct tape stupid.
You can't duct tape stupid.
- Thread starter
- #3
- Status
Similar threads
- Question