I have a client that has had a PRI or meglink for 6 years. For some reason the caller ID is displaying only their number on the outbound side. At some point it showed name. The Telco says they have no issue all features are turned on. I have been asked to go in. I have a few MICs systems out there with PRI. I do not recall that we send name out on Pri line. I know on BCM we can put in name not aware on MICS. Is there anything you guys can recommend ???
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
MICS SYSTEM
- Thread starter telllman
- Start date
- Thread starter
- #3
- Thread starter
- #5
curlycord
Programmer
Look under OLI programming
=----(((((((((()----=
curlycord
Toronto Canada
=----(((((((((()----=
curlycord
Toronto Canada
norstarboy125
Vendor
OLI# - Just deals with displaying what shows on outside number dialing hence (OUTGOING LINE IDENTIFICATION)
I would personally use Telco to handle displaying the name you want to display.
Jeremy J. Carter
Charm City Communications
Avaya/Nortel
Sales. Service. Installation
I would personally use Telco to handle displaying the name you want to display.
Jeremy J. Carter
Charm City Communications
Avaya/Nortel
Sales. Service. Installation
- Status
Similar threads
- Locked
- Question
- Locked
- Question