Mics PRI Upgrade 2

[jimmers]

It's been a few years since I'm done a PRI install on a Nortel and am just looking for some help.

I have a MIC's 6.1 with a Callpilot 100 2.0.

I have the 6 port fibre combo card, the PRI card, the PRI enabler and the PRI enabler keycode.

Now I remember how to program all the lines once the PRI is working, but what are the steps to actually install the cards? I'd hate to do somthing wrong and loose system programming. Thanks!

 

[notme11]

power the Mics Down
place the T1 cadd in trunk slot
power up
input key codes
change hardware to PRI
provision lines
assign target lines

 

[jimmers]

Thanks, but one last question! Where do you go to enter the keycodes? It's a feature code if memory serves me right.

 

[exsmogger]

Login to F**CONFIG and scroll to "Software keys" Input the PRI Enabler in 3 sets of 8 digits.

Brian Cox
Brian Cox Telecom Services

http://www.linkedin.com/in/briancox1952

 

[gtechjoe]

notme11 is correct. Also don't forget to add your destination code for making outside calls. Its after selecting your route.

 

[jimmers]

Thanks everyone!