MICS & RAD

[silver987]

Have a MICS eq/w 6.1xc and RAD,when I call in the display on the virtual phone is blank and it stays that way for quite awhile. I have found that if I switch to the M7324 it usually comes up. Could this be a flaky RAD?

Wayne T

 

[curlycord]

I used to think flaky line when that happened....just short the speed required. Maybe change baud rates.


=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[roadhg]

Trying to access MICS 7.1 with NRU10 RAD. It connects and I hear it answerall I get back in the window under Status is "listening for connections at 127.0.0.1", I'm lost can anyone help?

 

[silver987]

Roadhg, for the best response, you should start a new post.

Wayne T

 

[silver987]

Well the speed didn't work, I changed it to 9600 and I think that was worse. It's a pretty big system (over 100 sta) Could it be slow because of activity? I find in the early morning it seems to be OK.

Wayne T

 

[curlycord]

I doubt it.
All my sites with that issue have been in the outskirts or old areas.....4800 works for them best.

Try the lower lines if they have.




=----(((((((((()----=
curlycord

http://www.curlycord.com