Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MICS 7.1 not holding settings after restart - even after FastRAD/NRU restore

Status
Not open for further replies.

varrius

Technical User
Sep 27, 2006
19
US
I have a MICS 7.1 KSU, that doesn't seem to hold settings after losing power. I found this out as we just had an extended power outage and the MICS ran through the UPS on it and poof, settings gone. I had recently backed it up with NRU/FastRAD just in case of problems. So I restored the system programming from backup and it appears to complete successfully, performs a warm restart after being in Maintenance mode for about 5-10 minutes. Problem is, no settings have been restored. I looked at a copy of the backup file in notepad and I can clearly see set names and the like in the file. Any advice as to what could be the cause and possible remedies (other than kicking it to the curb)?

Thanks in advance.

Varrius
 
Brian,

Thanks for the reply. I was afraid it was something like that.

Varrius
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top