I have a new MICS 7.1 install. We are unable to activate Message Lamps on the analog station ports connected to the ASM/MW modules (three modules, doing all the same thing). We can generate stutter dial tone when there is a new voice mail message. Anybody with any ideas out there?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
MICS 7.1 ASM with MW
- Thread starter BCSTechs
- Start date
- Thread starter
- #3
curlycord
Programmer
Not supported that I know of.
Try changing your analog phones that recognize stuttered dialtone to light the light such as a home phone.
=----(((((((((()----=
curlycord
Try changing your analog phones that recognize stuttered dialtone to light the light such as a home phone.
=----(((((((((()----=
curlycord
curlycord
Programmer
Actualy I am not so sure the vmail gives stuttered dial tone, perhaps somebody else can confirm....I amybe think of PBX.
For Analog I used to setup Off Premise Noticfation to call the Internal phone like you would with a cell phone.
Use the proper COS depending how often you want to be bugged i.e. call my phone every half hour 9 times, or since CP try editing the COS to your liking.
=----(((((((((()----=
curlycord
For Analog I used to setup Off Premise Noticfation to call the Internal phone like you would with a cell phone.
Use the proper COS depending how often you want to be bugged i.e. call my phone every half hour 9 times, or since CP try editing the COS to your liking.
=----(((((((((()----=
curlycord
fireeater
Technical User
- Dec 10, 2008
- 780
- 0
- 0
correct ,under set programming you have ata settings for mwi
none = (guess)
tone = stuttered dial tone for 10 seconds
light = message waiting light on single line set (if equipped)
only thing i found funny is that only main set(direct dial) can set mwi on slt's with the feature 1 code, vmail can also
_____________________________________
S.H.A.D.O.
_____________________________________
mike
none = (guess)
tone = stuttered dial tone for 10 seconds
light = message waiting light on single line set (if equipped)
only thing i found funny is that only main set(direct dial) can set mwi on slt's with the feature 1 code, vmail can also
_____________________________________
S.H.A.D.O.
_____________________________________
mike
- Thread starter
- #8
curlycord
Programmer
Reminds me that that 1st release did not have MW until later.
=----(((((((((()----=
curlycord
=----(((((((((()----=
curlycord
- Status
