MICS 6.1 on PRI Remote access

[kvandmx]

Greetings All.

Do I need to set my DN Digits from 3 to 4 if I want to use a DISA DN with a DID? The programming is expecting a 4 digit DN number under set DN.

Thank you.

Kevin

 

[Sam173]

i beleive so

 

[ptstechnician]

If your trying to remote access the mics (via RAD), setup a Target Line and have the RAD answer it.

 

[hawks]

Your DISA DN is expecting the amount of digite that you have the Rec length set for. No need to change your system DN length just put the xxxx of the DID number that you want to hit DISA.

 

[kvandmx]

Thanks Hawks,
I set up the DISA DN as you described, Set a remote Pkg (4) and a COS Password without line restrictions. I dial the DID and get system dial tone, I enter the COS Password, Dial tone returns, However After that I am unable to do anything. I am just getting a fast busy. Does this set up allow dialing of internal extensions? I think I am missing something. Any help would be appreciated.

Thanks,
Kevin

 

[kvandmx]

Update: I am able to page and dial an external number but I am still unable to dial an internal extension. Is this a possibility on a PRI or am I missing a step?

Thanks,
Kevin

 

[Deweyhumbolt]

It's not meant to dial internal extensions. That's what an AA is for. It's only for remote page and getting access to outside lines.

Adversity is Opportunity

 

[kvandmx]

Thanks, I guess that does make sense. Well at any rate it is working for what management wanted, all that matters.

Thanks again,

Kevin