I have two cs1000e rel 7.5 fully patched connected to to a 1000M via session manager using sip trunks. Problem I am having is I can not access the ms lync number from tdm phones on either E. I can access it using IP phones from either the e's or the m. I can access it from tdm phones from the M. Is there something I need to look at to make this work. Any help will be appreciated. Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Microsoft Lync trouble
- Thread starter texan01
- Start date
- Thread starter
- #3
Thanks for the reply but I think i figured it out. Seems under PARM settings there is a MSEC prompt. It needed to be set to off. The reason the IP phones worked was because under their CLS setting it has MSNV.
MSEC (ON) OFF Enable Media Security for the system. Disable Media
Security. The device level settings are not effective
when this option is set for the system.
(MSNV) Media Security Never: Default setting for all
users. Implies that there is no attempt to secure
either incoming or outgoing calls.
MSEC (ON) OFF Enable Media Security for the system. Disable Media
Security. The device level settings are not effective
when this option is set for the system.
(MSNV) Media Security Never: Default setting for all
users. Implies that there is no attempt to secure
either incoming or outgoing calls.
Yeah, the msec is a common problem. I always set MSNV on the ipti members for the virtual trunk, that way we can have msbt on the sets for internal communication, rather than turn it off as default in the parm settings. But everyone has probably their own opinion on this as the MSEC is there for a reason.
I2007
I2007
- Status
Similar threads
- Locked
- Question