MG430 SYNC ALM - R6.2

[WellingtonPaez]

I have tried disabling the sync source from CLI. but now Avaya moved all to CM on 6.2.
I have checked System Parameter Features Sync Over IP and it is disabled. I have MAJ ALM on my gateway


show faul

CURRENTLY ACTIVE FAULTS
--------------------------------------------------------------------------
-- Hardware Faults --
+ Clock synchronization signal lost, 07/03-11:19:56.00

Current Alarm Indications, ALM LED is on
--------------------------------------------------------------------------
+ Clock SYNC Primary Fault

These are my Sync Sources=

SYNCHRONIZATION CONTROL: --- Remote ---

SOURCE MM or VoIP STATUS FAILURE
--------- ------------------- ----------------------- ---------------
Primary VoIP Standby Loss of Signal
Secondary Not Configured
Local v0 Active None

Active Source: v0 Sync Source Switching: Enabled

Done!

I also tried moving it to V0 from CLI. Again none of the SYNC commands work in the MG.

 

[montyzummer]

Have you upgraded the GW to the latest firmware??

APSS (SME)
ACSS (SME)
ACIS (UC)

 

[WellingtonPaez]

yes it is running the latest FW