When programming the DSPs on a MGC card, I believe (zero)- the top portion of the card - is high density. A 96-port daughter board would be programmed as: x x 11 and x x 12 and x x 13.
The lower port - for low density - would be: x x 0.
That leaves slot 14 and 15 for Virtual DTRs.
My question is: Can you program a DSP on slot 14 (x x 14); and if you could, where would the associated hardware be?
Thanks
The lower port - for low density - would be: x x 0.
That leaves slot 14 and 15 for Virtual DTRs.
My question is: Can you program a DSP on slot 14 (x x 14); and if you could, where would the associated hardware be?
Thanks
