Max PRI's?

[jacksonbush]

I'm installing a 400 w/exp that I'm sure was engineered wrong.
Its configured for 3 PRI and 3 dsm32's. I'm I right that I can only put 2 PRI's in this config?

 

[LKev]

Yes, only 2 PRI's on a 400. They should have been sold a 450.

Kevin

 

[jacksonbush]

Thanks,makes sense when you only have two clock sources.

 

[cook1082]

Yes you can, I have a 400 with 3.Can't remember the clock settings.

 

[option11newby]

Have also installed BCM400 with 3 x PRI.
Cant remember what the clock sources were either.

NCSS, NCDS, NCTS

 

[jacksonbush]

Did you guys do it with a remote gateway?

 

[cook1082]

They were 3 PRI's thru the CO.

 

[hawks]

all the clock source is asking which span should the system clock from. 1 span is Primary and the other is Secondary. If you add a third it still clocks from the Primary or Secondary source.

 

[jacksonbush]

So I can set one to Primary and two to secondary?

 

[Deweyhumbolt]

Hawks is correct, 1 Primary, the other 2 Secondary.

Adversity is Opportunity

 

[jacksonbush]

Thanks everyone for the help.

 

[hawks]

You should not get the option to set anything with the 3rd because remember the Clock is system wide. Everything will clock from the Primary until there is a problem then it goes to the Secondary. Hope this makes since.

 

[jacksonbush]

Yes, Thanks again.

 

[setenvjt]

whats happens to the 3rd PRI if its installed on a BCM 400. Is it backup only?

 

[Aerodesliza]

You can install three working PRI on your BCM 400 not only for backup