M12X0 Expansion questions

[28416909]

I just install a M12X0 expansion with 2 trunk cards. I have it all wired into the 8x24, and the KSU SEES the 8 lines. How do i use the lines though? I tried activating lines 9-12 but they say "not in service" when i try to use them. I have the M12X0 plugged into port 3 of the expansion on the KSU. How can i use my new lines?

 

[galfaro]

What type of expansion card are you using, 2 port or 6? And what's on it?
Also what slots do you have the trunk cards in on the Trunk module?
Gabriel

 

[28416909]

It is a 6 port expansion card labeled 3 4 5 6 7 and 8.

I have the TM M12x0 plugged into port 3.
They are in slots one and two;

They are each 4 port copper cards.

 

[28416909]

It is a 6 port expansion card.

I have my unit plugged into the 3rd plug in it.

I have 2 copper 4 port expasion card in the m12x0 TM

How do i make these 8 lines work?

 

[galfaro]

Your trunk module should be in port 8. What else do you have on that card? Your trunk modules start from top to bottom, station modules are from bottom to top. If port 8 is empty, put your trunk module on it.
Gabriel

 

[28416909]

Okay, Well do.. TM is in port 8 now. So should I be able to go in there and program the lines? which lines are they?

 

[galfaro]

you have an 8x24, so your lines should start at line 09, or 009, i don't remember.
Gabriel

 

[28416909]

009, but that doesent work. even though it shows up onder config>> modules

 

[VencomRob]

Did you enable the cards? That might prevent them from working. They should enable on a boot up, but maybe they didn't.

 

[28416909]

Yes they are enabled

 

[28416909]

How do i get theses things to work?

 

[curlycord]

Make sure the lines on reception are 009 and up.
Disable the card/s then re-enable.

 

[28416909]

How do i disable and re-enable?

 

[hawks]

GO to Maintenance then go to Module Status then show Module then to TC.

 

[28416909]

Got it, now, do i have to configure all lines 9 - 12 beforei can use 9?

 

[28416909]

Lines 9 - 12 still say "not in servie" when i try to use them. why?

They phone lines are connected properly.

 

[28416909]

Yeah, that only shows module status, it does not allow me to modify it at least I think. How do i chage its status?

 

[curlycord]

Line card in properly? and on the left side of 12X0?
Compatible line card?

 

[28416909]

Cool, thats all set, but i can't figure out how to get them to work.

It is plugged into port 3.

This should be lines 9 - 12 right?

So i have configured the lines, and I Add them to a hand set, then when the handset tries to access the line, it says "Not in service" I am not sure what to do. This hardware works because it was setup at one time before.

 

[28416909]

What's an answer DN? could that have any effect on this?
\