Local Upgrade leads to Non Bootable drive 1

[JimHilton]

Hey all, my Mitel VAR came onsite for an unrelated problem, but gave me the software for V5.x.x.x.

I have no intention installing this on the work system, but thought it would be ok to install on my home can.

Well things did not goes as planned, I can no longer boot off the drive in the SX200-ICP.

I used "local" for the upgrade. Here are the errors I am getting:

auto-booting...


boot device : ata=auto
unit number : 0
processor number : 0
file name : /Kts8250.vx
inet on ethernet (e) : 192.168.1.2:ffffff00
gateway inet (g) : 192.168.1.1
user (u) : ftp
ftp password (pw) : @
flags (f) : 0x0
other (o) : motfcc


Disk Configuration Started.
Creating block device for controller 0 drive 0... done.
Creating CBIO device for controller 0 drive 0... done.
Attaching to partition table for 1 partitions on controller 0 drive 0... done.
Creating Cache Layer for partition 0 (/ata00) on controller 0 drive 0... done.
Creating Dos FS device for partition 0 (/ata00) on controller 0 drive 0... done.
Disk Configuration Complete.
Loading /ata00/Kts8250.vx...n/a

Error auto-loading file: errno = 0x380003.
Can't load boot file!!

here is the boot parameters on start up:

[VxWorks Boot]: p

boot device : ata=auto
unit number : 0
processor number : 0
file name : /Kts8250.vx
inet on ethernet (e) : 192.168.1.2:ffffff00
gateway inet (g) : 192.168.1.1
user (u) : ftp
ftp password (pw) : @
flags (f) : 0x0
other (o) : motfcc

The controller just blinks with all alarm lights blinking. If you need more info just ask and i'll try to get you the relevant reports

Thanks!!

Jim

 

[JimHilton]

Hmmm one other thing, I have never seen the flash card LED go green always orange.