I am having problems accessing our local operator from call manager phones. Currently, the call reaches our 7206 gateway, but is rejected on the PBX end for "unallocated number".
Here is the dial-peer I have that the calls are using. From our PBX, 9 is always used to access outside lines, so we have used the same dialplan for phones from call manager.
dial-peer voice 91 pots
description "PSTN 9+ dialing via SL-100 (Primary)"
destination-pattern 9T
direct-inward-dial
port 1/1:23
forward-digits all
When the dialed digits "90" pass to the PBX, should give a local operator (9 for the access code, 0 for the operator.)
All other 9+ calls seem to work correctly, except for 90 and 900. Both 90 and 900 dialed calls reject due to isdn code "unallocated number"
Anyone else have this problem?
On IOS 12.3.5 if that matters.
Here is the dial-peer I have that the calls are using. From our PBX, 9 is always used to access outside lines, so we have used the same dialplan for phones from call manager.
dial-peer voice 91 pots
description "PSTN 9+ dialing via SL-100 (Primary)"
destination-pattern 9T
direct-inward-dial
port 1/1:23
forward-digits all
When the dialed digits "90" pass to the PBX, should give a local operator (9 for the access code, 0 for the operator.)
All other 9+ calls seem to work correctly, except for 90 and 900. Both 90 and 900 dialed calls reject due to isdn code "unallocated number"
Anyone else have this problem?
On IOS 12.3.5 if that matters.