Linking a Bay Accelar 1250 with a Cisco 4006 switch 2

[jcroe]

I have a Bay Accelar 1250 Routing switch in production, and I am trying to add a Cisco 4006 to it in order to have connectivity to the network so I can eventually replace the Accelar and push it out to another location. The 1000LX module on the 4006 will not sync up with the Accelar 1202LX-A 2pt blade. I have light on the accelar, but none on the cisco 4006. I have checked the fiber cable and it is within specs. Any ideas?

 

[mrawlyk]

LX module on 1250 is for long reach. You might need a conditioning mode fiber patch cable. You need on on both ends. You might be sending to hot a signel for a short distance. See the nortel support site.

 

[ZachBenj]

Make sure tagging and autonegotiate is turned off. My suggestions are what I would try myself. If incorrect, I welcome corrections to my knowledge.
Scott
s-tomlin@home.net

 

[jcroe]

Thanks guys,

I replace the cable with an appropiate one and turned off tagging and autonegotiate and the boxes are talking to each other perfectly and network traffic is balancing out nicely!

 

[robbiear]

Jcroe,

The tagging should not be part of the issue here and if required you should not see any problems between the two devices.

Robbiear