Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Line Blocked

Status
Not open for further replies.

ICFUC

Technical User
Oct 31, 2005
53
SE
Hi !

Code:
VERSION=CXP1010105/4/TSWSP02/R3A

I've got a strange error.....
When dialling from node A to node B over private net to ext 36544 I get a "Line Blocked" error ( directly when finished with 5:th digit ). I can without problems dial to any other extension in that series of....36541....36542...,...36549.
Internally in node B they can call to the ext 36544 and DID works fine.
Also from node C it works without problems.
Have checked LC & NA & NU in both node A & B, but I can't find anything about 36544 in there.

If I dial the DEST for node B to place the call directly, it doesn't work either.

I'm I missing something ? I'm running out of ideeas.
 
What kind of extension is 36544? Can you post the result of SUDIP:DIR=36544?
 
36544 is a DTS and SUSIP shows normal IDLE state.
And still there's no problem to dial internally in node B.
I'm not even shure that the call leaves the A node?
I try to send CTDEI on the ext in node A that I'm dialling from, but there isn't enough time to show anything.
 
Is there personal number initiated for 36544?
 
Hi !
No PEN !
Thinking of restarting SLP60 on both sides, but always a lot of traffic. It seems like the user has done a FME to an ext in node A and a FME from that extension in node A back to 36544, and the extension in node A does not longer exist....
Line are probably blocked due to loopback, but I'm not sure.
Suggestions anyone??
 
you say you can't find 36544 in node B but it is a digital extension, and the user from 36544 in node B has a FME to an ext that does not exist in node A, and this node A extension has a FME to 36544 - but it does not exist to put a FME on? this cannot all be correct, please post susip and sudip of 36544 on node B, and dest to send call to node B from node A and C. It does not sound like your problem is to do with SLP60 but programming. Also check NUTRP;

best parnum
 
Yes, if no PEN, it can be in NUTRP. As parnum said seems no deal with SLP60. If you think there is coordination mismatch try SFCEI first.
 
NO, have checked NU !
Also checked LC ( all TAB ) and NA.

To Parnum: I know you can't do a FME to an ext. that doesn't exist. But if you do FME over tie-line and then remove that ext. ? Node A has no knowledge about ext in node B

SUSIP and SUDIP shows OK as stated in earlier mess.
Note : it's possible to dial internally in Node B and over tie-line in Node C. The only problem exists in Node A ?? or on incoming side in Node B.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top